Address Programmer
GAST
Model: W3A
The W3A Address Programmer allows detector addresses to be electronically entered and verified, replacing the conventional mechanical switch-based addressing method.
Detector addresses can be manually programmed through P-NET (Power Line Communication), and the device also supports automatic address programming when a detector is replaced. In addition, it can diagnose repeater faults, check operating status, and verify the condition of communication lines.
- Features
-
· Auto Address Mode · Supports external power via USB-C · Repeater fault diagnosis and status check · Communication line status check
-
Communication Repeater -
Remote Annunciator -
Seismic Base -
Address Programmer
-
Detector Base -
Detector Base -
Flexible Conduit Holder -
MANUAL STATION SET -
.png)
Manual Call Point -
Manual Call Point -
INDICATOR LAMP -
FIRE ALARM BELL -
Sprinkler Manual Control Box -
MANUAL RELEASE STATION -
MANUAL STATION -
BOOSTER POWER SUPPLY -
Fire Power Supply Unit 15A -
BOOSTER POWER SUPPLY -
EMERGENCY POWER OUTLET SINGLE PHASE TYPE -
ELECTRONIC SIREN -
DISCHARGE LAMP -
STROBE -
Strobe Synchronization Module -
Fire Power Supply Unit 20A
Specifications
- ModelW3A
- KC Registration No.R-R-GSF-W3A
- Operating VoltageExternal: DC5V / 2A (USB-C Type) Internal: Battery (AAA x 4)
- Dimensions120(W) x 265(H) x 74(D) mm
- Weight520g
- ColorWhite
- MaterialABS
- Operating Environment-10℃ ~ +50℃, 0% ~ 90% RH
- Communication MethodP-NET (PLC Power Line Communication)